I just bought a rooter, to connect 2 computers in the same house. Only I cannot make the computer ''read'' the rooter, so it doesn't work. Can anyone help me with that?
Rooter connection threw 2 computers?network security
Ok, obviously you configured your network card to connect to the router (you did enable WEP or WAP Encryption- right?) Just follow along and see what you missed....or may have missed.
1) Did you connect the correct CAT5 wire to the router? You should have a phone line or coax cable going into your modem, a cat 5 (network wire) going from the modem to the WAN port of the router.
2) If you have DSL, most carriers use PPOE. If so, the router (if its not in gateway mode) must be set up using your ISP's Account information. (ie username/password) Usually on the index /first page of the router logon screen, there are settings that need to be configured. You usualyy have a drop down box where you can choose PPOE (or whatever service you have). If you choose PPOE, the username/password boxes should appear/become active.
3) If you are using cable, then most need the MAC address of the PC to be cloned before you can connect. Somewhere in the router, (depending on your model) , there should be a ''CLONE MAC ADDRESS setting. Enter (or hit the clone button if you have it) and apply the settings. The route should be in gateway mode. MAC addresses can be found in the hardware settings of the computer.